I shall personalise my tipper - Model 55

Bodywork

• Tipper platform in galvanised steel sheet HX500, thickness 3 mm
• Rectangular tube side members, height 120 or 140 mm (depending on cylinder) and longitudinal spacers
• Sideboards in galvanised steel H350ZMA, height 350 mm, thickness 2 mm, fold-down, removable, interchangeable right/left
• Sideboard lifting aid from length 4060 mm
• Closing of embedded sideboards
• Steel H350ZMA front face, height 450 mm, thickness 2 mm
• Cab Protect in galvanised steel, with grille (4.5 mm section), removable and without top cap
• Rear door in galvanised steel H350ZMA, height 450 mm, thickness 2 mm, automatic opening by cam at 15° (doorway 520 mm)
• Rubber opening stops on sideboards and rear door
• Rear pillars in galvanised steel, thickness 3 mm, removable, with adjustable fixing bolt and conical fittings
• Polypropylene fender flares with supports in unwrought aluminium
• Approved aluminium side protection, black powder paint
• Nickel Zinc treated bolts (5 times more resistant than standard galvanising)
• Tipping shaft without lubrication (self-lubricating ring)
• Short dumping overhang: 250 mm
• Outer frame adapted to lashing

 

SUBFRAME

• S355 steel tipper, thickness 4 mm
• Tipping by 3 or 4 expansion cylinder depending on length
• 48° tipping angle
• Electrically driven pump unit, 12 or 24 volts depending on the vehicle
• 7-litre tank
• Hydraulic pressure 180 bars
• Wired remote control in cab

 

SAFETY

• Safety solenoid valve on cylinder
• Circuit breaker
• Safety stand
• Double safety device on the upper door hinges

 

FINISH

• Galvanised elements: Steel sheet + 10 µm galvanisation + Shot blasting + 60 µm epoxy powder primer + 60 µm powder paint
• Non-galvanised elements: DKP metal sheet + Degreasing + Shot blasting + 60 µm powder primer + 60 µm powder paint


 

Filter by :