I shall personalise my tipper - RANGE 75

BODYWORK

• Tipper platform in steel sheet HX500, thickness 4 mm
• Rectangular tube side members, height 160 mm and longitudinal spacers
• Sideboards in galvanised steel S350, height 400 mm, thickness 2 mm, fold-down, removable, interchangeable right/left
• Assisted lifting for the sideboard from length of 4260 mm
• Closing of embedded sideboards
• Steel S355 front face, height 450 mm, thickness 2 mm
• Cab Protect in galvanised steel, with grille (4.5 mm section), removable and without top cap
• Rear door in steel S355, height 450 mm, thickness 2 mm, automatic opening (doorway 520 mm)
• Rubber opening stops on sideboards and rear door
• Rear pillars in galvanised steel, thickness 3 mm, removable, with adjustable fixing bolt and conical fittings
• Polypropylene fender flares with support in unwrought aluminium
• Approved double bar aluminium side protection, black powder paint
• Nickel Zinc treated bolts (5 times more resistant than standard galvanising)
• Tipping shaft without lubrication (self-lubricating ring)
• Short dumping overhang: 250 mm
• Outer frame adapted to lashing

SUBFRAME

• Tipper in S355 steel
• 5 mm thick side members, reinforced wings
• Tipping by 3 or 4 expansion cylinder depending on length
• Tipping capacity depending on length: 6 T (minimum)
• 48° tipping angle
• Electrically driven pump unit, 12 or 24 volts depending on the vehicle
• 12-litre tank
• Hydraulic pressure 180 bars
• Wired remote control in cab

SAFETY

• Safety solenoid valve on cylinder
• Circuit breaker
• Safety stand

FINISH

• Galvanised elements: Steel sheet + 10 µm galvanisation + Shot blasting + 60 µm epoxy powder primer + 60 µm powder paint
• Non-galvanised elements: DKP metal sheet + Degreasing + Shot blasting + 60 µm powder primer + 60 µm powder paint